RCA TV Antenna TVPRAMP1R User Guide

5. Connect the other end(s) of the antenna  
downlead(s) to the preamplifier.  
Digital Signal  
Preamplifier  
If you’re using separate UHF  
and VHF antennas, connect  
the separate downleads to  
their dedicated jacks on the  
preamplifier.  
For Outdoor Antennas  
TVPRAMP1R User’s Guide  
The TVPRAMP1R is designed specifically to improve the  
If you’re using a combined  
UHF/VHF antenna, connect the  
single downlead to the UHF/  
COMBINED INPUT jack on the  
preamplifier.  
performance of outdoor antennas in low signal strength areas,  
extending antenna range to give you the most channels and best  
reception possible. The TVPRAMP1R is engineered for digital  
signals, so it outperforms old preamps made for analog.  
Slide the weather boot(s) over  
the cable connector(s) and boot  
collar(s) on the preamplifier.  
Preamplifier Installation  
1. Set the VHF/UHF and FM TRAP switches on the  
bottom of the preamplifier.  
6. Connect to the power injector and TV/digital  
converter box.  
By default, the preamplifier is set  
to work with a single, combined  
Connect the downlead cable  
from the preamplifier to the TO  
ANT jack on the power injector.  
To TV/digital converter box  
From antenna  
VHF/UHF  
VHF/UHF antenna. If you want  
to use it with separate VHF and  
UHF antennas, use a small flathead screwdriver to set the switch  
on the bottom of the preamplifier to SEPARATE. (The switch is  
protected by a weatherproof cover that you’ll have to remove  
first.)  
SEPARATE COMMON  
Make sure your TV or digital  
converter box is turned off. Then  
attach the power injectors built-  
in coaxial cable to the antenna  
input jack on your TV or digital  
converter box.  
The preamplifiers FM Trap is set  
ON  
to ON by default. If you would  
like to turn it off, use a small  
flathead screwdriver to set this  
FM TRAP  
OFF  
7. Plug the power injector’s power cord into a  
standard wall outlet or surge protector.  
switch to OFF. (The switch is protected by a weatherproof cover  
that you’ll have to remove first.)  
The power injector must be  
plugged in INSIDE your house.  
Note: This power unit should  
be plugged in so that it stays  
vertical or lies flat.  
NOTE: For best perfomance, keep the FM trap in the ON  
position. If you use your antenna for FM as well as for TV  
broadcasts, switch the FM trap off. Please note, however,  
that switching the FM trap off may affect TV reception  
performance.  
WARNING: TO PREVENT  
FIRE OR SHOCK HAZARD,  
DO NOT EXPOSE POWER  
SUPPLY SECTION OF THIS  
APPLIANCE TO RAIN OR  
MOISTURE.  
IMPORTANT: Make sure the weatherproof covers for these  
switches are back in place before you mount the preamplifier  
to your antenna mast.  
8. Turn your TV or digital converter box back on and  
rescan for channels.  
2. Mount the preamplifier to your antenna mast.  
Position the U-bolt on the  
antenna mast where you want  
to mount the preamplifier. Make  
sure you mount it within easy  
reach.  
12 Month Limited Warranty  
Audiovox Electronics Corporation (the “Company”) warrants to the original retail purchaser of this product  
that should this product or any part thereof, under normal use and conditions, be proven defective in  
material or workmanship within 12 months from the date of original purchase, such defect(s) will be  
repaired or replaced (at the Companys option) without charge for parts and repair labor. To obtain repair  
or replacement within the terms of this Warranty, the product along with any accessories included in the  
original packaging is to be delivered with proof of warranty coverage (e.g. dated bill of sale), specification  
of defect(s), transportation prepaid, to the Company at the address shown below. Do not return this  
product to the Retailer.  
This Warranty is not transferable and does not cover product purchased, serviced or used outside the  
United States or Canada. The Warranty does not extend to the elimination of externally generated static  
or noise. This Warranty does not apply to costs incurred for installation, removal or reinstallation of the  
product, or, if in the Companys opinion, the product has been damaged through acts of nature, alteration,  
improper installation, mishandling, misuse, neglect, or accident. This Warranty does not cover damage  
caused by an AC adapter not provided with the product.  
Put the preamplifier on the  
U-bolt as shown. Then place  
the washers on both ends, followed by the nuts.  
NOTE: For best results, mount the preamplifier as close to  
the antenna as possible.  
THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR  
OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY’S LIABILITY  
EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT.  
3. Slide the weather boots over the antenna  
downlead(s).  
This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES,  
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR  
PURPOSE, SHALL BE LIMITED TO DURATION OF THIS WARRANTY. ANY ACTION FOR BREACH OF  
ANY WARRANTY HEREUNDER, INCLUDING ANY IMPLIED WARRANTY, MUST BE BROUGHT WITHIN  
A PERIOD OF 24 MONTHS FROM THE DATE OF ORIGINAL PURCHASE. IN NO CASE SHALL THE  
COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER. No  
person or representative is authorized to assume for the Company any liability other than expressed herein  
in connection with the sale of this product.  
Attach F-connectors to the  
coaxial cable(s) if necessary.  
4. Connect the antenna downlead(s) to your  
antenna(s).  
Some states/provinces do not allow limitations on how long an implied warranty lasts or the exclusion  
or limitation of incidental or consequential damage so the above limitations or exclusions may not apply  
to you. This Warranty gives you specific legal rights and you may also have other rights which vary from  
state/province to state/province.  
Leave enough slack in the cable(s) to form a drain loop.  
U.S.A.: Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, New York 11788  
CANADA: Audiovox Return Center, c/o Genco, 6685 Kennedy Road, Unit 3, Door 16, Mississauga, Ontario  
L5T 3A5  
You can secure the coaxial downleads to the mast with  
weatherproof tape or cable ties.  
Slide the weather boot(s) over the cable connector(s) and boot  
collar(s) on the antenna(s).  
© 2010 Audiovox Accessories Corporation  
Trademark(s) Registered  
Printed in China  
TVPRAMP1_IB_00  
 

Quantum Wheelchair INFMANU4169 User Guide
Raypak Network Card B6000 User Guide
RedMax Trimmer LRTZ2500 User Guide
Riccar Sewing Machine R1100 User Guide
Ricoh Microscope Magnifier WX4130n User Guide
Samsung Flat Panel Television 320P User Guide
Sanyo Air Conditioner 85464359981002 User Guide
Satco Products Indoor Furnishings R20 Soft Square User Guide
Schumacher Battery Charger 20071230 User Guide
Sennheiser Answering Machine 300 IEM G3 User Guide